Site Loader

Dome Camera Installation Manual Weatherproof and Indoor versions www. Contents Introduction. Menu System Manual. Page 4 of 1. THE DENNARD TYPE DOME CAMERA. The Dennard Dome Camera is a precision unit, offering a wide. The Dedicated Micros Camera has a number of features which can be selected by the System. Supervisor when the dome is installed. Any of these can be.

Author: Taule Dogul
Country: China
Language: English (Spanish)
Genre: Automotive
Published (Last): 20 April 2014
Pages: 124
PDF File Size: 10.2 Mb
ePub File Size: 4.67 Mb
ISBN: 792-3-83592-798-8
Downloads: 41678
Price: Free* [*Free Regsitration Required]
Uploader: Nile

This will provide a noticeable improvement in camera performance at both the wide and telephoto end of the lens zoom range. Page 35 Control Switches – Indoor Dome Dome in co-ax mode requires video level be set to 1V p-p. Always support dome with bond prior to mating connector. From above, clamp to the tile via 2 x off split clamp rings C. Comments to this Manuals Your Name.

For example using the 36x optical zoom on a standard UK car number plate can be viewed at full screen width up to 17m away from the camera versus 11m away with 18x camera, or 13m away 26x. Secure the mounting disc with 4 x supplied off M6 socket button head fixings D. Sign in Dnnard have an account?

  ISO 8501-2 PDF

Remove and retain the four screws securing the shield to the head and lift off the shield. Also, when I have tested the cameras successfully and come to install, I have purchased a reel of RG6 u co-azial cable as I have read I will get a better signal than the more common RG59, is that a good enough solution?

Fit the supplied safety bond E to an attachment point in the ceiling. Camera Version To verify the version of camera supported by the dome software; 1.

Offer the dome enclosure up to the ceiling mounting disk, shown upper right engaging the screw heads C into the keyhole slots on the base of the dome F enclosure. Arecont Vision Contera indoor dome series.

Dedicated Mircros Dennard Installation manual |

Up The Coax Configuration Scan across the table to identify the values for the blue and yellow switches. Page 26 Termination All Dedicated Micros domes are fitted with a termination switch, shown above. Locate SW3 on the main PCB adjacent to the mounted connector attaching the daughter board housing the yellow and blue address switches. Troubleshooting No joystick dead band recognized as joystick was off centre during powerup.

Don’t have an account? Check the continuity on the power and video cables. Wall Mounting Bracket Note: Patrol mode is cancelled with any manual zoom action. Follow the instructions to access the address switches, then unscrew 4x posi screws that hold the mechanism mounting in place and unclip the connector from the rear.

  FORMULAIRE 8D PDF

Got it, continue to print. Twist to locate and lock. Browsing from the Americas?

Dedicated Micros Dennard 2060 Dome with 36x optical zoom

This offers a range of features which are described below. Control Switches – Indoor Dome Up the Coax Configuration Switch settings The switches are color coded, blue and yellow, xennard are located inside the dome camera housing. DM with rx domes are delivered with the address switches set at Always support dome with bond prior to mating connector.

Ceiling installation is made easier by removing an adjacent ceiling tile during installation. Indoor domes are rated to IP50 and are not sealed against water ingress. Advanced privacy patches, preset positions and tour facilities. The connector mates with the dome as shown in the image below.

Introduction The Dedicated Micros camera is a precision unit, offering a wide variable speed range, together with a large pre-set memory for positions, tours and alarm responses.